It’s a common misconception that people believe stretch film and shrink film are the same thing. It’s true that both shrink and stretch films are designed to unitize products onto pallets and both are generally made from polyethylene resins. Shrink films are produced on blown film lines and stretch films can be produced on either blown or cast film lines. Outside of those similarities, the two packaging systems don’t have a lot of other common characteristics.
Shrink films contain a high percentage of low density polyethylene (LDPE), which is the same type of resin used to make bread bags and newspaper overwrap sleeves. When fabricated under very specific parameters, LDPE gives shrink film its “shrink”. The stress or tension required to make the film contract is frozen in during the fabrication process. To activate shrink film, a heat source is required such as a heat tunnel, heat gun, or torch. When sufficient heat is applied to the film, it approaches its melting point and the film begins to draw up or “shrink”. Because the film can only shrink so far, each product to be wrapped has to be matched with a specific size and configuration of film. As film resins go, LDPE does not have good puncture or tear resistance and has a relatively low load holding force. In order to provide sufficient load containment and protection for the load, these films are generally several times thicker than most stretch films.
In contrast, most stretch films contain high levels of linear low density polyethylene (LLDPE) and, depending on the end-use application, can stretch from 25 to 300%. Stretch films are either designed to be applied by hand or by machine. Hand films usually have minimal stretch (25-100%) in order to aid the operator in applying the product and are in many ways similar to a large roll of very thin tape. Machine films on the other hand can have very high stretch levels (150 -300%) and, because they are applied by automated equipment, can be configured to exert very high levels of tension on a load if desired.
Shrink films are good for applications where the object to be protected requires five-sided protection (top and four sides) or is very large (boats and industrial equipment). For five-sided protection on finished products such as washer/dryers, refrigerators and other appliances, along with bagged resins and cement/concrete, stretch hooders have started replacing shrink films as the older shrink tunnels are decommissioned and new, more energy efficient equipment takes its place.
If you have any interest in shrink film machine, I recommend that you can visit the website of Jumbo Steel Machinery Co., Ltd.
For over 25 years, Jumbo Steel has dedicated itself to the research of production technology for PVC shrinkable film. The company has made great improvements in product prescription and machine performance, upgrading the quality and efficiency of PVC shrinkable films. Jumbo Steel PVC shrink film machine has been sold worldwide, and has earned a reputation for its superior machine and outstanding production know-how. Get more details please do not hesitate to send inquiry or contact with Jumbo Steel immediately.
Article Source: http://www.paragon-u.com/bid/252257/Stretch-Film-vs-Shrink-Film-What-s-the-Difference